In this lab activity,make a network that is similar to the one…

Question Answered step-by-step In this lab activity,make a network that is similar to the one… In this lab activity,make a network that is similar to the one shown in the Topology Diagram. Begin by cabling the network as shown in the Topology Diagram. then perform the switch port configurations required for security. Use the IP addresses that are provided in the Topology Diagram to apply an addressing scheme to the network devices. When the network configuration is complete, examine the port security to verify that the network is operating properly.Part 1: Configure Port Security Task 1: Access the command line for S1 and enable port security on Fast Ethernet ports 0/1 and 0/2.[insert screenshot] Task 2: Set the maximum so that only device can access the on Fast Ethernet ports 0/1 and 0/2.[insert screenshot] Task 3: Secure the ports so that the MAC address of the device is dynamically learned and address to the running configuration. Task 4: Set the violations so that the Fast Ethernet ports 0/1 and 0/2 are not disabled when a violation occurs, but packets are dropped from am unknows source.[insert screenshot] Task 5: Disable all the remaining unused ports, Hint: use the range keyword to apply this configuration to all the ports simultaneously.[insert screenshot] Image transcription textLearning Objectives Upon completion of this lab, you will be able to: Cable a network according to theTopology Diagram. Configure port security Verify port security In this lab activity, you will configure and verifyport security on a switch. Port security allows you to restrict a port’s ingress traffic by limiting the … Show more… Show more Computer Science Engineering & Technology Networking COMPUTER S BIS2004 Share QuestionEmailCopy link Comments (0)